|
|
|
|
This portable rebar bender was designed by a contractor and allows you to bend steel in place even in tight areas.
- Ideal for standard hook or off-set (dog leg) bends. Straightens rebar from less than 30 degrees
- Versatile design cannot be trapped against a wall or obstruction. Bending wheel is easily removed without tools
- Costs for couplers, joint welds and inspection delays are greatly minimized
- Saves time by allowing the removal of column forms prior to bending rebar
- Bends #11 1 3/8-inch (35 mm) rebar to an ACI approved radius and ideal for general purpose bending with up to #12 1 1/2-inch (38 mm) rebar
Technical Documentation
|
|
|
|
| Max. Bending Angle |
90 |
| Max. Rebar Size |
#8, #9, #10, #11 |
| Min. Bending Angle* |
14 in |
356 mm |
Min. Bar Spacing
on Center |
3.5 |
ACI Approved
Max. Bending Angle** |
90 |
ACI Approved
Max. Rebar Size |
#11 |
|
| Overall Length |
27 in |
686 mm |
| Overall Width |
19 in |
483 mm |
| Overall Height |
6 in |
152 mm |
| Shipping Dimensions |
30 x 13 x 6 in
762 x 330.2 x 609.6 mm
|
| Operating Weight |
110 lb |
50 kg |
| Shipping Weight |
136 lb |
62 kg |
|
All JB Series Rebar Benders require a seperately purchased drive motor to function.
Click below to see Multiquip's availible Drive Motors.
>>JB11090
|
|
| Applications |
90° Standard Hook
180° Cane Hook
Stirrup and Tie Hook
Seismic Stirrup and Tie Hook
Offset Bends
Straightening
|
| Accessories |
10-foot hose with coupler |
|
|
|
|
* Minimum Bend measured from bottom of the machine to the top of the bend angle.
**American Concrete Institute has approved the wheel used in this device as the proper radius for bending the bar size indicated; CRSI requirements are met for the bar size indicated. |
Notice: Features and equipment specifications are subject to change without notice.
